Min Copy Memory; Format Fax Storage; Auto Color Adj; Adf Edge Erase - Lexmark X543 Service Manual

7525-xxx

Min Copy Memory

This setting allocates the amount of DRAM memory to be used for storing copy jobs in the queue. 25, 35,50,80
and 100 MB are the available settings. To adjust the minimum copy memory, perform the following steps:
In the configuration menu, scroll to the MinCopy Memory item, and press
1.
2. Use the or
When the desired value is displayed, press
3.

Format Fax Storage

This setting allows the user to format non volatile fax storage memory. While formatting is taking place,
Formatting Fax Flash DO NOT POWER OFF appears. After formatting is complete, the display reverts to the main
menu.

Auto Color Adj

Sets the suggested number of pages which the printer should print between consecutive calibrations.
Selections are Off and the values between 100 and 1000 in increments of 50. The default is 500 pages.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received
while printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job
in order to perform a calibration. If a user is using the menus, including the Configuration Menu and the
Diagnostics Menu, an automatic color adjust calibration does not occur.
When an event other than page count triggers this calibration, the count that monitors the maximum number of
pages printed will be reset. For example, if the user replaces an empty toner cartridge, the next time the printer
is started, it will sense the new cartridge and perform the automatic color adjustment, even though the page
counter for Auto Color Adj is fewer than required. The Auto Color Adj page counter is then reset.
Note: An automatic color adjust can also be initiated manually. This calibration procedure should be performed
when the MFPs internal print settings are changed. To perform and automatic color adjust, perform the following
steps:
press to enter the Administration menu.
1.
2. press or
press .
3.
press or
4.
press .
5.
press or
6.
. Calibrating displays. Ready will display when the calibration procedures complete.
7. press
press twice to exit the Administration menu.
8.

ADF Edge Erase

This menu item sets the size, in millimeters, of the no-print area around an ADF scan job.All copy jobs have a
minimum of a two millimeter border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
In the Configuration menu, select the ADF Edge Erase menu item.
1.
Press or
2.
3. When the desired value is displayed, press
Service Manual
3-34
to increase or decrease the setting's value.
to scroll to the Settings menu.
to scroll to the Quality menu.
to scroll to the Color Adjust menu item.
to increase or decrease the setting's value.
.
.
.
Previous
Next
Go Back