Lexmark X543 Service Manual page 72

7525-xxx
Fax error log codes (continued)
Error code
80A
80B
80C
80D
80E
811
812
813
814
815
818
819
81A
880
881
Service Manual
2-28
Description
T5 Timeout occurred when transmitting
image data to remote fax device.
Too many errors when transmitting in
ECM mode.
Remote device failed to respond to the
CTC command.
Received too many requests from
remote end to repeat the previous
command sent.
Functional limitation- Remote fax
device does not support G3 receive
capability.
Failed to detect a fax device at the
remote end.
No more data rates available in V34
modulation scheme.
Timeout occurred after waiting too long
to receive a good frame.
Tried too many times at selected speed
using V34 modulation scheme.
Fax transmission was interrupted due
to power failure.
Fax transmission failed due to
insufficient memory to store scanned
image.
Fax transmission failed due to
insufficient memory to store received
image.
A timeout occurred during transmission
of a page in ECM mode.
Failure to transmit training successfully
in V17, V29, V27 terminal modulation
schemes.
Failure to transmit training successfully
in V33, V29, V27 terminal modulation
schemes.
Action
• Check line quality.
• Adjust 'Transmit Level'.
• Select a lower 'Max Speed'value under
Fax Send settings.
• Check line quality.
• Adjust 'Transmit Level'.
• Select a lower 'Max Speed'value under
Fax Send settings.
• Select a lower 'Max Speed' value
under Fax Send settings.
• Adjust 'Transmit Level'.
• Check line quality.
• Adjust 'Transmit Level'.
• Check if line conditions on remote end
will facilitate a good connection.
No action needed. Issue with the remote
device.
• Verify MFD is answering to fax call and
not a voice call.
• Decrease value of 'Rings To Answer'
setting.
• Adjust to a lower modulation scheme.
• Adjust "Receive Threshold".
• Adjust 'Transmit Level'.
• Adjust to a lower modulation scheme.
• Troubleshoot MFP if error persists. See
"Modem / fax card service check"
on page 2-74.
Adjust 'Memory Use' setting to allocate
more memory for send jobs.
Adjust 'Memory Use' setting to allocate
more memory for receive jobs.
Select a lower 'Max Speed' value under
Fax Send settings.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
Previous
Next
Go Back