Factory Scanner; Factory Manual; Miscellaneous Tests; Motor Detect - Lexmark X543 Service Manual

7525-xxx

Factory Scanner

Note: This setting is not used by field service.

Factory Manual

Note: This setting is not used by field service.

Miscellaneous Tests

Motor Detect

This test initiates an automatic motor detection process that should be performed whenever the controller board
is replaced.
To run Motor Detect:
1. Select MISC TESTS in the Diag Menu, and press Select (
Remove Cartridge. press Select appears.
Select Motor Detect.
2.
Note: Do not press Select yet.
Remove all toner cartridges and the imaging unit.
3.
Close the front cover.
4.
If you press Select before closing the front cover, a message appears: Close Cover. press Select.
press Select (
5.
Motor Detection In Progress... appears.
The motor detection process takes about 10 seconds, and stops automatically.
Detect Complete. Rebooting... appears, and the printer performs a POR (Power On Reset).
Service Manual
3-10
).
).
Previous
Next
Go Back