Lexmark X543 Service Manual page 54

7525-xxx
User status and attendance messages (continued)
User primary message Explanation
37 Insufficient memory
for flash defragment
operation
38 Memory Full
39 Complex Page
40 <color> Invalid Refill,
change cartridge
50 PPDS Font Error
51 Defective Flash
Detected
Service Manual
2-10
This message is displayed when insufficient printer memory is available to perform
Flash Memory Defragment operation.
This message appears prior to the actual start of the defragment operation.
press Select ( ) to stop the defragment operation.
To perform the defragment operation, you can:
• Delete fonts, macros, and other data in RAM.
• Install additional printer memory.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting Menu:
- Cancel Job
- Reset Printer
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
This message is displayed when the printer is processing an incoming job and there
is not enough memory available to continue processing the job.
The following actions can be taken:
• Determine how to make more memory available to your print job by:
- Deleting fonts, macros and other data in RAM.
- Simplify your print job.
- Install additional memory
• press Select ( ) to clear the message and continue printing.
The job may not print correctly.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
This message is displayed when a page is too complex to print.
The following actions can be taken:
• press Select ( to clear the message and continue printing.
The job may not print correctly.
• Simplify the print job.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
- Reset Printer
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
Replace the toner cartridge with a new one.
This error only occurs when a printer is formatting PPDS print data.
The PPDS interpreter has detected a font error. When a specific font, which is not
installed, is requested based on a PPDS mode Set Font Global command, a Select
Code Page command, or a Comprehensive Font Selection command, and the printer
Best Fit setting is off. If Best Fit is on, the printer performs a best fit search to find a
similar font, and this error does not occur.
This error also displays when the printer receives invalid PPDS download font data.
The following actions can be taken while this message is displayed:
• press Select ( to clear the message and continue printing.
The job may not print correctly.
• press Menus ( to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
press Select ( to clear the message and continue printing.
You must install different flash memory before you can download any resources to
flash.
Previous
Next
Go Back