Sending Messages To Lcd Speakerphones - Comdial DXP Impact Reference Manual

GCA70–249
8.2

Sending Messages To LCD Speakerphones

You can set system-supplied messages at your station to be received and
displayed by a calling LCD speakerphone. These messages give the
caller information on your telephone status. Get a list of the available
messages from the attendant and write them on the blank chart on the
next page.
• To turn on a message from your telephone,
1. Press INTERCOM, then dial
2. Press # to clear current message if one is stored.
3. Dial the desired code number from your message list (01–30) on
the next page. If you use the default messages Back at and Call,
add to them as follows:
For Back at message, dial the code for time numbers and colon
from dialing codes table (for example, dial # 12 00 01 29 04 05 for
a space and the time 01:45).
For Call message, dial code for telephone number of where you'll
be (for example, dial # 12 09 07 08 15 02 02 00 00 for a space and
the number 978–2200,
4. Press #, then press SPEAKER to end message.
5. INTERCOM light flashes.
• To turn off the message and your intercom light,
1. Press INTERCOM, then dial
Sending And Receiving Non-Verbal Messages
02.
#
02.
Non-LCD Reference Manual 8 – 3