Table of Contents
Advertisement
Using The Other Telephone Features
• To transfer a call over an E & M tie line,
1. Answer the incoming call.
2. Press the TRANSFER/CONFERENCE button.
(You can eliminate this step if the installer has configured your
system for quick transfer and you are accessing the E & M line
with a group access code.)
3. Dial the E & M access code that was assigned by the installer, or
dial 9 (if your system was configured by the installer to use
Automatic Route Selection (ARS)).
—OR—
press the E & M line button, if programmed by the installer.
4. Wait until you hear a dial tone, then dial the intercom number for
the party you wish to reach at the remote site. You will hear a fast
busy signal if you dialed an invalid number.
5. If you are doing a screened transfer, stay on the line until the called
party answers so that you can announce the call,
—OR—
hang up (unscreened transfer). If the called party does not answer,
the call will return to you after the transfer recall timer expires.
NOTE: When you transfer a call to the remote end of the E & M tie
line, you create an unattended conference causing your
telephone to appear as though it is on hold.
6. Press TAP button to rejoin the transferred call.
7. After rejoining the conference, press # to place the call on hold
again or hang up to terminate the call.
If neither party hangs up, or you have not terminated the call, the call
will return to you when the line-to-line connection timer expires.
7 – 20 Non-LCD Reference Manual
GCA70–249
Advertisement
Table of Contents
