Oki MB760 Service Manual page 353

05/ Sub
Mode Element
08 element
08 Setting System General Memory
Mode
08 Setting System Initialization
Mode
08 Setting System User Counter installed
Mode interface externally
08 Setting System FInisher Finisher tray
mode operating mode
08 Setting System FInisher Finisher tray
mode operating mode
08 Setting System FInisher Finisher tray
mode operating mode
08 Setting System FInisher Finisher tray
mode operating mode
08 Setting System FInisher Finisher tray
mode operating mode
08 Setting System FInisher Finisher tray
mode operating mode
08 Setting System Scanning
mode
08 Setting System Maintenance General
Mode
08 Setting System User Display setting
Mode interface
45641001TH Rev.1
Sub-
Item Subitem Code
code
9020
9030
9037
9048 0
9048 1
9048 2
9048 3
9048 4
9048 5
9049
9050
9051
Default Acceptable
Details RAM
value value
Size information of - - SYS Displays the sizes of the main memory and page memory.
memory
Initialization after - - SYS Perform this code when the software in this equipment
software version
up
Job handling-short 1 0-1 SYS Sets whether pause or stop the printing job when it is
paid-coin controller
Operating mode 1 0 0-1 SYS For plain paper, thick 1, LG. For non-sort mode and
Operating mode 2 0 0-1 SYS For thick 2. Do not change this setting unless otherwise
Operating mode 3 0 0-1 SYS For thick 3. Do not change this setting unless otherwise
Operating mode 4 0 0-1 SYS For thick 4. Do not change this setting unless otherwise
Operating mode 5 0 0-1 SYS For LG. For Single-sided stapling. Do not change this
Operating mode 6 0 0-1 SYS For single-sided stapling. Do not change this setting
Scanning operating 0 0-1 SYS Do not change this setting unless otherwise instructed.
mode
Performing panel - - SYS Performs the calibration of the pressing position on the
calibration
Panel calibration 0 0-1 SYS Switches whether the screen for displaying panel
setting value
Oki Data CONFIDENTIAL
Contents
Enables to check if each memory is properly recognized.
has been upgraded.
short paid using a coin controller.
0: Pause the job
1: Stop the job
sort mode. Do not change this setting unless otherwise
instructed.
0: Disabled 1: Enabled
instructed.
0: Disabled 1: Enabled
instructed.
0: Disabled 1: Enabled
instructed.
0: Disabled 1: Enabled
setting unless otherwise instructed.
0: Disabled 1: Enabled
unless otherwise instructed.
0: Disabled 1: Enabled
0: Operating mode 1
1: Operating mode 2
touch panel (LCD screen).
The calibration is performed by pressing 4 reference
positions after this code is started up.
calibration setting values is displayed or not.
0: Disabled (screen not displayed)
1: Enabled (screen displayed)
Proce-
dure
2
3
1
4
4
4
4
4
4
1
1
1
11-55 /