Backup Files - Oki MB760 Service Manual

9.1.3

Backup files

The following files are saved in the root directory of the USB device by backing up.
Modelname_MFPSerialNo_yyyy-MM-dd_
hh-mm
9.1.4 Cloning procedure
[a] Backup procedure
(1) Press the [ON/OFF] button to shut down the equipment.
(2) Connect the USB device [1] to the USB port [2] on the right upper cover.
Notes:
Backing up cannot be performed with multiple USB device [1] connected at the
same time.
(3) Turn the power ON while pressing [6] and the [CLEAR] button simultaneously.
(4) When "SRAM Clear Mode" appears on the LCD, key in [0] to select "0. Set Serial
Number" and then press the [START] button.
(5) Key in the serial number on the label attached to the rear cover of the equipment, and
then press the [OK] button.
(6) "Serial Number Setting completed" is displayed.
(7) Turn the power OFF.
(8) Turn the power ON while pressing the [5] and [9] buttons simultaneously.
(9) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering
anything.)
(10) Select "1. Backup SRAM Data to USB", and then press the [START] button.
(11) Enter a password (max. 15 characters) set for the backup data.
(12) "Backup Successfully done Restore the MFP" is displayed on the LCD screen when
the backup has been properly completed.
(13) Press the [ON/OFF] button to shut down the equipment.
45641001TH Rev.1
Filename
[1]
Fig. 9-3
Remark
E.g.: When backup was performed at 13:59 on
October 1st, 2010.
T290_CUK911379_2010-10-01_13-59
[2]
Oki Data CONFIDENTIAL
9-2 /