Oki MB760 Service Manual page 129

[F101_0] HDD connection error (HDD connection cannot be detected.)
[F101_1] Root partition mount error (HDD formatting fails.)
[F101_2][F101_3] Partition mount error (The HDD cannot be connected (mounted) caused
by damage to areas other than those described in the F101_1 and F101_4 to F101_9 errors.)
Classification
Other service call
Check item
HDD, SYS board, Setting
Replacement part
HDD
SYS board
45641001TH Rev.1
HDD unmounted: Connection of HDD cannot be detected.
Sub-code 0: HDD connection error (HDD connection cannot be detected.)
Sub-code 1: Root partition mount error (HDD formatting fails.)
Sub-code 2, 3: Partition mount error (The areas other than those
described in the F101_1 and F101_4 to F101_9 errors are damaged.)
1. Turn the power of the equipment OFF and check the connection of
the HDD.
- Connector and harness check
- Check if the connector pins of the HDD are bent.
- Check if HDD for other equipment is not installed.
- Check if SRAM for other equipment is not installed.
2. If the error still occurs after step 1, perform the following.
- Perform [3C] - [5] (Key Backup Restore) and check that each Key
Status is "OK".
- If not, recover the key (copy "SRAM Key Status" to "FROM Key
Status" or vice versa).
3. If the error still persists after step 2, perform the following.
- Perform [3C] - [3] (Format HDD), and then install "System Software
(HD data)" with [49] - [4].
Notes:
The following items will be deleted by performing
[3C] - [3] (Format HDD).
• Message Log
• Job Log
• Spool Data (Print, Email reception)
• Template
If F101_1 occurs with ADI-HDD or the error persists after
performing step 3, perform step 3 after performing [4]+[C]+[POWER]
→ 1. Revert factory initial status HDD.
4. If the error persists even after step 3, replace the HDD.
Oki Data CONFIDENTIAL
Contents
Measures
Measure
5-46 /