Oki MB760 Service Manual page 26

• Test mode (03)
Refer to  P. 3-7 "3.3 Input check (Test mode 03)" and & P. 3-9 "3.4 Output check (test mode
03)".
• Test print mode (04)
Refer to  P. 3-9 "3.5 Test print mode (test mode 04)".
• Adjustment mode (05)
Refer to  P. 3-10 "3.6 Operation Procedure in Adjustment Mode (05)",  P. 3-12 "3.7 Test
print pattern in Adjustment Mode (05)", and "Appendix" - "Adjustment Code (05)."
Notes:
When the power should be turned OFF, be sure to shut down the equipment by pressing
the [ON/OFF] button for a few seconds.
Remarks:
• In "RAM", the SRAM of the board in which the data of each code is stored is indicated. "PU"
stands for the PU board and "SYS" stands for the SYS board.
• Setting mode (08)
Refer to  P. 3-13 "3.8 Operation Procedure in Setting Mode (08)" and "Appendix" - "Setting
Code (08)."
Notes:
When the power should be turned OFF, be sure to shut down the equipment by pressing
the [ON/OFF] button for a few seconds.
Remarks:
• In "RAM", the SRAM of the board in which the data of each code is stored is indicated. "PU"
stands for the PU board, "SYS", "NIC" or "UTY" stands for the SYS board.
• Maintenance mode (68)
Refer to "5.2 Maintenance menu functions" in the Hardware Guide.
• Assist mode (3C)
Refer to  P. 3-15 "3.9 Assist Mode (3C)".
• HDD assist mode (4C)
Refer to  P. 3-18 "3.10 HDD Assist Mode (4C)".
• File system recovery mode (5C)
Refer to  P. 3-23 "3.11 File System Recovery Mode (5C)".
• SRAM clear mode (6C)
Refer to  P. 3-27 "3.12 SRAM Clear Mode (6C)".
• List print mode (9S)
Refer to  P. 3-29 "3.13 List print mode (9S)".
• Firmware update mode (49/89)
Refer to  P. 8-1 "8. FIRMWARE UPDATING".
45641001TH Rev.1
Oki Data CONFIDENTIAL
3-3 /