JRC JMA-932B-SA User Manual page 110

Procedures 1
2
3
4
Note: The radar does not start transmission if you press [TX/STBY] key while Preheat is
indicated.
Check that the ship's mains are turned on.
Press [POWER] key.
The system is turned on, and the preheating time is displayed.
Preheat is indicated at the upper left of the radar display.
Also the procedure of data backup is displayed.
See section "8.2 REGULAR BACKUP" about data backup.
Wait until the preheating time is over.
When the preheating time is over, the preheating time screen disappears, and Preheat
at the upper left of the radar display changes to
Press [TX/STBY] key.
The radar will start transmission and the antenna will start rotating.
Standby at the upper left of the radar display changes to Transmit .
Preheating time
3-3
Standby .