JRC JMA-932B-SA User Manual page 266

[II] Target Tracking Simulator
Pseudo targets are generated in certain known positions to check whether the target tracking units are operating
normally. Since the pseudo targets move depending on known parameters, the values for these pseudo targets
can be compared with the known value if the pseudo targets are acquired and tracked, and displayed. Thus, it
can be checked if the system is operating normally.
Procedures 1
2
3
4
5
Target tracking simulator / scenario
Scenario
1
2
3
4
5
6
Note: When the simulator is operating, set 0° as the heading bearing, and 0 kn as the speed of own ship.
When the range between own ship and the pseudo target is 0, the target will disappear.
Press the [TX/STBY] key to stop the transmitting.
The equipment will enter the transmission standby state.
Open the TT Test Menu by performing the following menu operation.
TT
→ TT Test Menu
Left-click the item button of
The setting items for TT Simulator will be displayed.
Select the scenario to be set.
Press the [TX/STBY] key to transmit.
The simulator will be activated and generate pseudo targets. The characters "X" at the
bottom of the radar display blinks indicating that the simulation mode is active.
Target start point
Distance Bearing
3.2nm
6nm
6nm every 18°
6nm
6nm
6nm
TT Simulator .
Target end point
Distance
20° 1nm
0nm
0°
1nm
1nm
45°
6nm
45°
6nm
45°
5-27
Pseudo-target speed
Bearing
90° 20kn
10kn
0°
every 18° 10kn
105kn
45°
20kn
150°
20kn
150°