Display User Map; Create User Map (Mark/Line); 3.6.1.1 Plotting A Mark - JRC JMA-932B-SA User Manual

3.6

DISPLAY USER MAP

Up to 20,000 items of Mark/Line can be created, displayed, loaded, and saved. (This function is available
only when navigation equipment is connected to this radar system.)
Marks that can be used
Lines that can be used
Color of mark and lines that can be used : 8 colors
Display only marks
If radar video is poor visibility caused by user map function, press the [DATA OFF] key to map displays
temporarily off.

3.6.1 Create User Map (Mark/Line)

In this system, when the radar is in the transmission state, the user map is displayed all the time. However,
valid latitude/longitude data and true bearing data must be entered into the system.
The user map can be created and edited by performing the following operation.

3.6.1.1 Plotting a mark

Procedures 1 Open the Mark With Cursor menu by performing the menu operation
below.
The Mark With Cursor menu will appear.
Display with "Map Make" in the cursor mode (in the upper right of the radar display).
2 Select the mark type use with the Type combo box.
3 Select the color type use with the Color combo box.
4 Left-click at a desired location on the radar display.
The specified mark will be displayed in the specified color.
To create another mark, repeat the above procedures.
: 5 types
: 3 types (solid, broken, and dashed-dotted line)
: 10 types
U.Map
→ Edit User Map
→ Make With Cursor
3-46

3.6 Display User Map

3