Lucent Technologies TransTalk 9000 Installation And Use Manual page 91

Handset
84
To determine sound clarity, listen to the simulated dial tone as you walk around.
6
A clear, steady tone indicates good sound clarity.
7 To determine signal strength, press 1.
The display shows the signal strength (SIG) for both the handset (HS) and the
base (B) (the radio module) at the moment that 1 was pressed, using a number
from 1 to 10, as shown in the following display:
The higher the number, the stronger the signal, as shown in the following table.
You can press 1 again to show a subsequent signal-strength reading. Each time
you press 1, you get a new reading.
Display Number
10
8 To determine voice quality, press 2.
The display shows the voice quality (QUAL) for both the handset (HS) and the
base (B) (the radio module) using a number from 1 to 10, as shown in the
following display:
3
ON
Signal Strength Is
Strong
9
Strong
8 Strong
7 Very Good
6 Very Good
5
Good
4
Good to Fair
3
Fair
2
Near end of range
1
Near end of range/loss of link
ON
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
Using the MDW 9031/9031DCP
Pocket Phone
503-801-166 — Issue 3 — October 1999