Lucent Technologies TransTalk 9000 Installation And Use Manual page 123

Procedures
Symptom
No ring on an incoming
call.
While you are talking
and walking, handset
beeps and RANGE
flashes in handset
display.
While you are talking
and walking, handset
beeps and RANGE
flashes in handset
display. You keep
walking away from
handset's matching
radio module, handset
double beeps five times,
display goes blank, and
your call appears to be
disconnected.
After placing a call on
Hold, you walk away
from handset's
matching radio module.
Your handset beeps,
handset display flashes
RANGE, and your call
appears to be
disconnected.
116
Possible Causes
Handset is out of range of its
matching radio module.
• Station wiring is incorrect.
• Radio module station wiring is
not connected to the switch.
Station port is set to NO RING
Handset antenna is not fully extended.
You are approaching an out-of-range
condition.
You are out of range of the radio
module. YOUR CALL HAS NOT
BEEN DISCONNECTED. IT HAS
BEEN PLACED ON HOLD.
You are out of range of the radio
module. YOUR CALL HAS NOT
BEEN DISCONNECTED. IT IS
STILL ON HOLD.
Possible solutions
Move the handset closer to the radio
module.
Check your station wiring, referring
to the table in "Radio Module/Switch
Wiring" in Chapter 2, and your
switch manual's station port wiring
configuration.
Check your switch manual for the
correct settings.
Fully extend the handset antenna.
Move back toward the handset's
matching radio module until the
display stops showing RANGE.
Move back toward the radio module.
Press O, then proceed as you
would for any call placed on Hold.
Move back toward the radio module.
Press O, then proceed as you
would for any call placed on Hold.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
5
Troubleshooting