Lucent Technologies TransTalk 9000 Installation And Use Manual page 86

Handset
Enabling or Disabling
Line Preselection
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
While still holding ", press O.
3
The handset beeps twice, and the display shows the handset settings, indicating
that you are now in Local Mode. (While in Local Mode, the MDW
9031/9031DCP can still receive notification of incoming calls.)
If the vibrator is enabled, the VIBR icon appears in the display. For example:
If the vibrator is disabled, no icon appears.
Press "V" (8) on the dialpad to enable or disable the vibrator.
4
5 Press O to exit Local Mode.
Note:
Both the alerter and the vibrator can be disabled at the same time. In this
case the only notification you have of an incoming call is that a line status
indicator (a truncated triangle or a rectangle, depending on your
communications system) flashes in the display.
Line Preselection lets you choose the line or button you want to use before turning the
handset on. For example, suppose your phone is ringing but you want to pick up a call
that is holding on another line instead of the ringing call. In normal operation, the
communications system automatically connects you to the ringing line as soon as you
turn on the handset. With Line Preselection enabled, you can select the line you want
to connect to before turning on the handset.
Notes: Enabling Line Preselection lets the user retrieve both lines of display by
pressing the Column button programmed for SCROLL, without turning
the handset "on."
Under certain conditions, the communications system tries to turn on a
speaker; for example, if you use Line Preselection to select a button
programmed for speed-dialing. Since the MDW 9031/9031DCP Pocket
Phone has no speaker, the system causes the ON icon in the handset
display to flutter, and the handset emits a continuous double beep. You
must press O to complete the connection.
When Line Preselection is enabled, you do not have to use it; however
you cannot use it unless it is enabled.
To enable Line Preselection, use the following procedure:
1 Make sure the handset is turned off.
2 Press and hold the Select button ( " ) for three seconds.
3
ON
Using the MDW 9031/9031DCP
Pocket Phone
79