Lucent Technologies TransTalk 9000 Installation And Use Manual page 126

Procedures
Symptoms
SPARE LED on battery
charger flashes red.
Handset is in the battery
charger cradle and the
HANDSET LED does
not light.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
Possible Causes
Battery pack is defective.
Contacts on the battery pack or in the
battery charger's spare battery
compartment are dirty.
Battery pack is not seated properly in
the spare battery compartment.
Handset is not seated properly in the
battery charger cradle.
Battery power supply is not plugged
in.
5
Troubleshooting
Possible Solutions
If you have a battery pack in the
handset and one in the spare battery
compartment, remove both battery
packs from the charger to clear the
red flashing LED. Then test each
battery pack separately as follows:
Insert the battery pack in the
1
handset and place the handset in
the battery charger's handset
cradle.
Wait one minute. If the
2
HANDSET LED flashes red,
order a new battery pack.
Verify that there are no
1
obstructions on the battery pack
or battery charger contacts.
2 Unplug the charger and clean
the contacts with a soft eraser.
3 Clean the battery pack contacts
with a soft eraser.
Reseat the battery pack in the
battery charger's spare battery
compartment, as described in
Chapter 3.
Reseat the handset in the battery
charger cradle.
Check that the charger power cord
is plugged into the charger and into
an electrical outlet that is not
controlled by a wall switch.
119