Lucent Technologies TransTalk 9000 Installation And Use Manual page 153

GENERAL <BlueItalic9>Continued<BlueDingbat9>Ø
Electrical
Specifications:
(Power)
Battery Pack Life:
RF SYSTEM PARAMETERS:
Frequency Band:
Channel Spacing:
Total Channel
Capability:
Duplex Method:
Transmitter
Output Power:
Receiver
Sensitivity:
OTHER:
Electrical
Requirements:
Requirements For
Out-Of-Building
Extensions:
Wiring:
146
Handset
Battery Charger (BC)
Radio Module (RM)
Carrier (CA) w/6 RMs
Power Supply (BC)
Power Supply (RM)
Power Supply (CA)
Standard Nickel Metal Hydride
Extended Nickel Metal Hydride
902 – 928 MHz
150 KHz
50 (Channels Dynamically Allocated out of 173)
Time Division Duplex (TDD) (Transmit and Receive on same frequency)
Dynamic Power Adjustment: 1 mW ERP Minimum to 160 mW ERP Maximum
-103 dBm at Antenna Port
105–130VAC, 50–60 Hz, 3-prong outlet separate ground, separately at 15 amps
•
• Outlet must not be controlled by an on/off switch
• Grounding to comply with Underwriters Laboratories (UL) 1459
Installation of a telephone or other standard (tip/ring) device in another building requires
the following In-Range Out-of-Building (IROB) to protect the switch/control unit and
telephone device from surges:
MDW 9031/9031DCP Pocket Phone: two Lucent Technologies 146D protectors
•
(ETR); two Lucent Technologies 146E protectors (ATL)
• MDW 9031/9031DCP Pocket Phone: Lucent Technologies SYSTIMAX
2-pair (4-wire) star ("home run" not "loop") ETR
Lucent Technologies SYSTIMAX or at least 4-pair (8-wire) star ("homerun" not
•
"loop") ATL
Bridging Adapter: Lucent Technologies 267F2 (ETR)
•
Bridging Adapter: Lucent Technologies 267C (ATL)
•
Range: 1,000 feet (305 m) for the Radio Module (26 AWG)
•
1.0 watt
15 watts
4.0 watts
24 watts
15 watts (10V 1.5 A)
6.0 watts (10V 600 mA)
30 watts (9V)
3 hours talk time/22 hours standby time
8 hours talk time/72 hours standby time
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
C
Specifications
®
or at least