Lucent Technologies TransTalk 9000 Installation And Use Manual page 119

Transtalk 9000 digital wireless system mdw 9031/9031dcp pocket phone
Hide thumbs Also See for TransTalk 9000:
Table of Contents

Advertisement

Procedures
Symptom
(Continued)
Voice quality in a
specific location is poor
and noisy.
Voice quality for calls is
lower than expected.
112
Possible Causes
You have a malfunctioning radio
module.
Handset is too close to the carrier(s).
Handset antenna is only partially
extended.
There are environmental limitations.
You are using different models of
handsets and the mix is incompatible
with the carrier.
Possible Solutions
1
2
3
Move the handset at least 6 feet
(1.8 m) away for a one- or two-
carrier setup, or 10 feet (3.1 m)
away for a three-carrier setup.
Fully extend the handset antenna.
Reinstall the radio module or carrier
away from electrical equipment and
as high as possible on the wall [but
with radio module antennas 6 to 12
inches (15.2 to 30.5 cm) from the
ceiling]. (See "General Positioning
Rules" in Chapter 2 for more
information.)
See "TransTalk 9000 System" in
Chapter 1.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
5
Troubleshooting
Remove all but one radio
module from the carrier. (See
"Removing Radio Module from
Carrier" in Chapter 4.)
Test each radio module
individually, verifying that the
POWER and PASS LEDs on
each radio module lights when
the carrier is powered, and that
the OUT OF SYNC LED is not
lit.
If the PASS LED does not light,
the radio module is
malfunctioning. Replace the
radio module and handset.

Advertisement

Table of Contents
loading

Table of Contents