Lucent Technologies TransTalk 9000 Installation And Use Manual page 59

Installing Multiple Carriers
52
At this stage of your installation, verify that the LEDs displayed match the first or
3
fourth lines of the SYNC and CONTROL/EXP LED Codes label.
4 If an OUT OF SYNC LED is lit, power down, wait at least 15 seconds, and then
repower the carriers in order from left to right, as described in Step 8 in
"Installing a Single Radio Module in Each Carrier." If the LED is still lit, follow
the suggestions in the "Installation Problems" section of Chapter 5,
"Troubleshooting." If the LED is still lit, call Customer Support as described in
the Copyright and Legal Notices at the beginning of this book.
4 T RANS T ALK
CAU TI O N
USE CABL ONLY E
AT&T 7896
84766 P⁄N I N
OUT
OF SYN C
OUT
1 2 3 4 5 6
2
Installing the MDW 9031/9031DCP
Y N C
O F S
L /
O U T
T R O
C O N
I O N
A N S
E X P
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
Pocket Phone