Lucent Technologies TransTalk 9000 Installation And Use Manual page 69

Handset
62
Press and hold "M" (6) for three seconds to enter Button Mapping Mode.
4
The handset display shows one of the following:
MAP:P
MAP:D
MAP:M1
MAP:M2
Press " repeatedly to cycle through the settings until the display appropriate
5
for your communications system is shown.
Press O when the correct setting is displayed.
6
The top line of the display shows information appropriate to the communications
system you are using.
7 To verify your setting, repeat Steps 1–3. The top line of the display should appear
as follows, depending upon your communications system:
PARTNER Systems
DEFINITY Systems, System 25, System 75, and
System 85
All MERLIN Systems (except MERLIN 410 and
MERLIN 820), including MERLIN LEGEND
MERLIN 410 and MERLIN 820
For a description of the button mapping between the MDW 9031/9031DCP Pocket
Phone and the wired telephones for your communications system, or to program
features on buttons, see the appropriate "Button Mapping" topics in Chapter 6.
2
Installing the MDW 9031/9031DCP
PARTNER Systems
DEFINITY Systems, System 25, System 75, and
System 85
Note: The MDW 9031DCP should only be set
to MAP:D for DEFINITY.
All MERLIN Systems (except MERLIN 410
and MERLIN 820), including MERLIN LEGEND
MERLIN 410 and MERLIN 820
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
Pocket Phone
LCL:P
LCL:D
LCL:M1
LCL:M2
503-801-166 — Issue 3 — October 1999