Lucent Technologies TransTalk 9000 Installation And Use Manual page 144

MDW 9031DCP Compatibility
add station next
SITE DATA
Room:
Jack:
Cable:
Floor:
Building:
ABBREVIATED DIALING
List1:
BUTTON ASSIGNMENTS
1: (A) call-appr
2: (B) call-appr
3: (C) call-appr
4: (1)
5: (2)
Note: Page 3 above is the recommended button programming. The Feat/P button must be pressed
twice to Exit from the Softkey menu (for example, exiting Directory mode). Button 8 on the
MDW 9031DCP phone, when used with Line Preselection, allows for toggling between the
two lines of display information.
add station next
SOFTKEY BUTTON ASSIGNMENTS
1
2:
3:
4:
5:
7:
6:
8:
9:
10:
11:
12:
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
The following illustrations show in parentheses the MDW 9031DCP Pocket Phone
button assignments on Pages 3 and 4 of the STATION Administration screens. The
button labeled D on the MDW 9031DCP Pocket Phone display automatically defaults
to the button labeled 04 (Drop) on the 8410D phones.
STATION
List2:
STATION
Note: All Softkey button assignments should be initially removed
when administering an MDW 9031DCP terminal. The desired Softkey
features can then be properly programmed on the DCP Pocket Phone
Programmable buttons (buttons 1-7). Button 8 is a firmware-
programmed hard Scroll button on the MDW 9031DCP phone.
Page
Headset? n
Speaker? n
Mounting: d
Cord Length: 0
Set Color:
List3:
6: (3)
7: (4)
8: (5)(Dir)
9: (6)(Next)
10: (7)(Call Display)
Page
6
MDW 9031/9031DCP Pocket
Phone Compatibility
3 of 4 SPE B
4 of 4 SPE B
137