Installing Multiple Carriers
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
At this stage of your installation, verify the LEDs displayed match the third of the
3
SYNC and CONTROL/EXP LED Codes label, depending on whether the carrier
is the control or an expansion carrier.
4
If the LEDs on your installation do not reflect this pattern, there is probably a
mistake in the cabling. Power down the carriers and check that you have correctly
followed Steps 6 through 8 in "Mounting and Cabling Multiple Carriers." If you
are still having problems, see Chapter 5, "Troubleshooting."
If your LEDs match the pattern in the illustration, you can feel confident that your
5
carriers are cabled correctly.
Go to
"Installing a Single Radio Module in Each Carrier" (page
6
2
Installing the MDW 9031/9031DCP
Pocket Phone
48).
47