Lucent Technologies TransTalk 9000 Installation And Use Manual page 125

Procedures
Symptoms
HANDSET LED
flashes red.
SPARE LED on battery
charger does not light
when battery pack is
placed in spare battery
compartment.
118
Possible Causes
Battery pack is defective.
Contacts in the handset cradle or on
the battery pack are dirty.
Handset is not seated properly in
battery charger's handset cradle.
Battery pack is not seated properly in
the spare battery compartment.
Contacts on the battery pack or in the
spare battery compartment are dirty.
Battery pack is defective.
Possible Solutions
If you have a battery pack in the
handset and one in the spare battery
compartment, remove both battery
packs from the charger to clear the
red flashing LED. Then test each
battery pack separately as follows:
1
2
1
2
3
Reseat the handset in the battery
charger's handset cradle, as
described in Chapter 3.
Reseat the battery pack in the
battery charger's spare battery
compartment.
1
2
3
1
2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
5
Troubleshooting
Place the battery pack in the
battery charger's spare battery
compartment.
Wait one minute. If the SPARE
LED flashes red, order a new
battery pack.
Verify that there are no
obstructions on the handset or
battery charger contacts.
Unplug the charger and clean
the contacts with a soft eraser.
Clean the handset contacts with
a soft eraser.
Verify that there are no
obstructions on the battery pack
or battery charger contacts.
Unplug the charger and clean
the contacts with a soft eraser.
Clean the battery pack contacts
with a soft eraser.
Insert the questionable battery
pack in the handset and place
the handset in the handset
cradle.
Wait one minute. If the
HANDSET LED flashes red,
order a new battery pack.