Lucent Technologies TransTalk 9000 Installation And Use Manual page 66

Installing Multiple Carriers
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
If an OUT OF SYNC LED is lit, power down, wait at least 15 seconds, and then
3
repower the carriers in order from left to right, as described in Step 9 in
"Installing the Remaining Radio Modules." If the LED is still lit, follow the
suggestions in the "Installation Problems" section of Chapter 5,
"Troubleshooting." If the LED is still lit, call Customer Support as described in
the Copyright and Legal Notices at the beginning of this book.
4 T RANS T ALK
1 2 3 4 5 6
4 The PASS and POWER LEDs on all radio modules should be lit and green,
indicating that all of the radio modules are functional. If a radio module's PASS
LED is not lit:
a Power down the carriers.
From the wall outlet, unplug the power cord/AC adapter of the radio module
b
that did not light.
Wait 15 seconds.
c
Plug in the radio module's power cord again.
d
Repower the carriers, following the proper left-to-right order.
e
If the PASS LED is still not lit, follow the suggestions in the "Installation
Problems" section of Chapter 5, "Troubleshooting." If the LED is still not lit,
call Customer Support as described in the Copyright and Legal Notices at the
beginning of this book.
Go to "Handset" (page
5
2
Installing the MDW 9031/9031DCP
Y N C
O F S
L /
O U T
T R O
C O N
I O N
A N S
E X P
O N
CAU TI
USE ONLY E
AT&T CABL 7896
P⁄N 84766 I N
OUT
C
OF SYN
OUT
60).
Pocket Phone
59