Lucent Technologies TransTalk 9000 Installation And Use Manual page 42

Installing a Single Carrier
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 — Issue 3 — October 1999
Place the carrier on its feet towards the back of the shelf or desk, making sure it is
10
in a stable position. Be sure the telephone line cords come out the rear exit slots in
the back of the unit. Arrange the power cord and telephone line cords beneath the
shelf or desk, so no one can step on them or trip over them.
11 Insert the carrier's power cord into the AC adapter, then plug the power cord into
a properly grounded, 3-prong wall outlet that is not controlled by an on/off
switch.
If appropriate, you can wall-mount the AC adapter using its attached wall-
mounting bracket.
!
CAUTION:
Never connect or disconnect telephone line cords, or insert or remove radio
modules, while the carrier is plugged into the wall outlet.
Go to "Single Carrier Installation Self-Test" (page
12
2
Installing the MDW 9031/9031DCP
40).
Pocket Phone
35