Carriage Shaft / Carriage Unit - Epson WorkForce 1100 Service Manual

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
 Attach the Label, Ink Position (parts code: 1510078) at the
position in the figure below.
1mm ± 1mm
Figure 4-55. Attaching the Label, Ink Position
After replacing the Printer Mechanism, always make the required
A D J U S T M E N T
R E Q U I R E D
adjustments referring to the following.
 "Chapter 5
Adjustment
Disassembly And Assembly
25 mm
Label, Ink Position
(p.128)"
Disassembling the Printer Mechanism

4.4.5 Carriage Shaft / Carriage Unit

When only removing the Carriage Shaft, you do not need to
C H E C K
P O I N T
perform "5.3.2 PG Adjustment
position of the rib on the Parallelism Adjust Bushing (Left/Right)
before removing them, and make sure to align the markings with
the ribs when installing them.
Parallelism Adjust Bushing (Left)
Mark the position of the rib
Figure 4-56. Marking Position
1. Remove the Printhead / CSIC Assy. (p.81)
2. Remove the CR Scale. (p.79)
3. Remove the APG Assy. (p.78)
4. Rotate the PG Cam (Right) to adjust its positions other than PG++ downside.
Figure 4-57. Adjusting the PG Cam
Revision C
(p143)". In that case, mark the
Parallelism Adjust Bushing (Right)
Mark the position of the rib
PG Cam (Right)
88
Confidential