Epson WorkForce 1100 Service Manual page 90

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
Place the feet of Left PG Torsion Spring and Right PG Torsion
Spring on the Carriage Shaft.
Left Side
Figure 4-61. Reinstalling PG Torsion Springs
8. Remove CR Shaft Mounting Plate Fixed Spring from the tab and notch on the
Main Frame, and pull out the spring in the direction of the arrow.
CR Shaft Mounting Plate Fixed Spring
Tab
Figure 4-62. Removing CR Shaft Mounting Plate Fixed Spring
Insert the foot of CR Shaft Mounting Plate Fixed Spring into the
notch on the Main Frame (rear side).
Disassembly And Assembly
Right Side
Foot
Foot
Notch (rear side)
Notch
(See Figure 4-62 (p.90))
Disassembling the Printer Mechanism
9. Remove the extension spring for the Driven Pulley Holder from the Main Frame
and the tab on the Drive Pulley Holder with needle-nose pliers.
Extension spring for the
Driven Pulley Holder
Driven Pulley Holder
Figure 4-63. Removing the Extension Spring for the Driven Pulley Holder
10. Slide Driven Pulley Holder to the right end of the notch on the Main Frame, and
Remove the Driven Pulley Holder toward you.
Driven Pulley
Driven Pulley Holder
Figure 4-64. Removing the Driven Pulley Holder
Tabs
Confidential
Revision C
90