Epson WorkForce 1100 Service Manual page 97

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
5. Disconnect all the cables and the FFCs from the connectors on the Relay Board.
 CN1 : Relay FFC
 CN2 : PE Sensor cable
 CN6 : PF Encoder Sensor FFC
6. Peel off the acetate tape, and disconnect all the FFCs from the connectors on the
Main Board, and release it from the groove on the ASF Assy.
7. Remove the APG Motor cable and PE Sensor cable from the ASF Assy.
8. Peel off the PF Encoder FFC secured by two pieces of double-sided adhesive tape
from the ASF Assy.
Double-
sided
tapes
Groove
APG Motor cable
Acetate tape
Main Board
Figure 4-83. Releasing the Cables (2)
Referring to Figure 4-83, correctly route each of the cables and
FFCs.
Disassembly And Assembly
Relay Board
PF Encoder
PE Sensor cable Sensor FFC
Disassembling the Printer Mechanism
When only removing the ASF Assy, you do not need to perform
C H E C K
P O I N T
"5.3.5 ASF Guide Roller LDs Position Adjustment
case, mark the installing positions of the Guide Roller LDs before
removing them, and make sure to align the markings when
installing the Guide Roller LDs.
Figure 4-84. Marking Position
9. Remove the two C.B. M3 x 6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide
Roller LDs.
Guide Roller LD
LD Roller Shaft
Figure 4-85. Removing the Guide Roller LD
Revision C
(p150)". In that
Front 17) C.B. M3x6
Face (8±1 kgf.cm)
Tab
Guide pin
Guide Roller LD
97
Confidential