Epson WorkForce 1100 Service Manual page 73

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
REMOVING THE PRINTER COVER
1. Remove the Upper Housing / Printer Cover. (p.72)
2. Remove the two C.B.P. M3 x 8 screws that secure Printer Cover Holder Left/
Right.
4) C.B.P. M3x8
(6±1 kgf.cm)
Tabs
Printer Cover Holder Right
Figure 4-17. Removing the Printer Cover Holder Left/Right
Insert the tabs (two each on the left/right) shown in
the holes on the Upper Housing.
Disassembly And Assembly
4) C.B.P. M3x8
(6±1 kgf.cm)
Upper Housing
Printer Cover Holder Left
Figure 4-17
Be careful not to damage the surface in step 3 and later.
C A U T I O N
3. Remove the Printer Cover Holder Right following the steps below.
3-1. With the Printer Cover open, put the Upper Housing with the rear side up.
When performing the following steps, be careful not to damage the
C A U T I O N
tabs of the Printer Cover Holder Right.
Tabs
3-2. Slide the Printer Cover Holder Right in the direction of the arrow while
lifting it, and remove the Printer Cover Holder Right from the Upper
Housing.
Upper Housing
into
4. While holding the Printer Cover, remove the Printer Cover Holder Left in the same
manner as Step 3-2, and remove the Printer Cover from the Upper Housing.
Removing the Housings
Tab
Figure 4-18. Removing the Printer Cover
Revision C
Printer Cover
Holder Right
Printer Cover
73
Confidential