Epson WorkForce 1100 Service Manual page 160

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
6.1.3.1 Lubrication of Carriage Shaft
1. Fit the Carriage Unit onto the Carriage Shaft, and move it to the center of the
Shaft.
In the following step, do not bring the needle of a syringe into
C A U T I O N
contact with the Carriage Shaft.
2. Using a syringe, lubricate the holes (2 places) at both ends of the Carriage Unit
rear side with grease.
Lubrication Type
G-71
Carriage Unit
Carriage Shaft
Figure 6-19. Lubricating the Carriage Shaft (1)
Maintenance
Lubrication Amount
140mg ± 10mg x 2 points
Holes
3. Hold the Carriage Unit, and while turning the Carriage Shaft clockwise and
counterclockwise, move the Carriage Unit to spread the grease evenly.
Figure 6-20. Lubricating the Carriage Shaft (2)
4. Move the Carriage Unit to the right end of the Carriage Shaft viewing the Unit
from the rear, and lubricate grease with the syringe at the point shown in refer to
Figure 6-21.
Lubrication Type
G-71
Lubrication Point
Figure 6-21. Lubricating the Carriage Shaft (3)
Overview
Revision C
Lubrication Amount
140mg ± 10mg x 2 points
Confidential
160