Epson WorkForce 1100 Service Manual page 87

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
When performing the following step, make sure to grasp the Printer
C A U T I O N
Mechanism by the specified positions shown below. Otherwise, the
frames may become deformed.
Figure 4-52. Handling the Printer Mechanism
5. Lift the Printer Mechanism grasping it by the holding positions with your hands,
and remove it from the Lower Housing.
 Install the Printer Mechanism to the Lower Housing as follows.
(refer to Figure
1. Align the two guide pins with the positioning holes as shown
below.
Right Rear
Positioning hole
and guide pin
Figure 4-53. Reinstalling the Printer Mechanism
Disassembly And Assembly
Holding Positions
4-51)
Left Rear
Positioning hole
and guide pin
Disassembling the Printer Mechanism
2. Place the Printer Mechanism on the Lower Housing and
secure the Shield Plate Holder and the Printer Mechanism
with the screw (A).
3. Verify the Printer Mechanism and Lower Housing are
tightly engaged (no rattling), and then secure the Shield Plate
Holder to the Lower Housing.
4. Secure the Printer Mechanism and Lower Housing with
screws (x5). (Tighten the screws in the order shown in
4-51)
5. Secure the electrode cable to the Front Paper Guide with the
screw.
 Route the Ink Tube and the Waste Ink Tube through the three
grooves of the Lower Housing.
Waste Ink Tube
Figure 4-54. Reinstalling the Waste Ink Tube
Revision C
Figure
Ink Tube
Groove
87
Confidential