Carriage Unit Setting / Screws Securing Carriage, C - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
8. Set the "Carriage Unit" on the "HEAD EXCHANGE SUPPORT TOOL".
(Refer to Figure 4-110.)
When setting the "Carriage Unit" on the "HEAD
C H E C K
EXCHANGE SUPPORT TOOL", take care not to bend the
P O I N T
"Tube, Supply, Ink". If it get bend, replace with a new
one.
Make sure the "Carriage Unit" is installed to the "HEAD
EXCHANGE SUPPORT TOOL" securely.
Make sure that the "Carriage Unit" is completely set into
the position with its bottom is parallel to the tool as seen
from the side of the "Carriage Unit".
Check Point
9. Attach the "CUTTER CAP" to the cutter section of the "Carriage Unit".
(Refer to Figure 4-110.)
The "CUTTER CAP", which covers the cutter blade projecting
C H E C K
upward from the bottom of the Carriage, prevents injury
P O I N T
during the work.
10. Remove the three screws that secure the "Carriage, C" from the bottom of
the "Carriage Unit".(Refer to Figure 4-110.)
C.C.P. 2.6 x 8: 3 pcs.
Disassembly & Assembly
Figure 4-110. Carriage Unit Setting / Screws Securing Carriage, C
Disassembly Procedures
Carriage, C
Revision C
CUTTER CAP
HEAD EXCHANGE
SUPPORT TOOL
C.P.P. 2.6x8
288