Epson WorkForce 1100 Service Manual page 33

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
Occurrence
Phenomenon Detail
Timing
At power-on The printer does not operate at all. Power Supply
At operation Operation at power-on is normal,
but the error appears when the
print job is sent to the printer.
Troubleshooting
Table 3-2. Troubleshooting of Communication Error
Faulty Part/
Part Name
3. Check that the Fuse F1 on the Power Supply Board has not
Board blown.
Fuse F1
4. Check the components on the Power Supply Board for damage. 4. Replace the Power Supply Board with a new
Interface cable 1. Check that the Interface cable is connected between the PC and
printer.
2. Check the Interface cable for breaking.
USB 1. Check that the PC and printer are connected via the USB hub.
Printer Driver 1. Check that the printer driver for WorkForce 1100/Epson Stylus
Office T1110/B1100/T1100/Epson ME Office 1100 has already
been installed.
2. Check that the connected printer is WorkForce 1100/Epson
Stylus Office T1110/B1100/T1100/Epson ME Office 1100.
Main Board 1. Check that a wrong model name has not been input to the
EEPROM on the Main Board.
Overview
Check Point
Power Supply
Board
Revision C
Remedy
3. Replace the Power Supply Board with a new
one.
one.
1. Connect the Interface cable to the PC and
printer.
2. Replace the Interface cable with a new one.
1. Configure the USB ID setting.
Refer to Chapter 5 ?Adjustment?.
1. Install the printer driver for WorkForce 1100/
Epson Stylus Office T1110/B1100/T1100/
Epson ME Office 1100.
2. Connect the WorkForce 1100/Epson Stylus
Office T1110/B1100/T1100/Epson ME Office
1100 printer.
1. Make the initial setting using the Adjustment
Program.
Refer to Chapter 5?Adjustment?.
Confidential
33