Epson WorkForce 1100 Service Manual page 84

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
11. Disconnect the CSIC FFC from the connector on the CSIC Assy, and remove the
CSIC Assy from the Carriage Unit.
Figure 4-45. Removing the CSIC Assy (5)
12. Remove the three C.B.P. M2.6 x 8 screws that secure the Printhead using the
Phillips Screw Driver, No.1, and vertically lift the Printhead to remove it.
2
Figure 4-46. Removing the Printhead
Disassembly And Assembly
CSIC Assy
CSIC FFC
Printhead
1
3
7) C.B.P. M2.6x8
(3±0.5 kgf.cm)
Disassembling the Printer Mechanism
13. Peel off the Head FFC from the Printhead.
14. Remove the two Head FFCs from the connectors of the Printhead.
Printhead
Figure 4-47. Remove the Head FFC
 Confirm that the pad is attached at the position in
Figure 4-48. Attaching the Pad
Revision C
Double-sided tape
Head FFCs
connectors
Figure 4-48.
Pad
84
Confidential