Lower Housing / Printer Mechanism - Epson WorkForce 1100 Service Manual

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.4.4 Lower Housing / Printer Mechanism

1. Remove the Upper Housing / Printer Cover. (p.72)
2. Grip both ends of the Waste Ink Tube Fasteners with your fingers, slide them in
the direction of the arrows, and pull out the Waste Ink Tube from the Joint Tube.
3. Remove the C.B.P. M3 x 12 screw and the C.B.S. (P2) M3 x 10 screw that secure
the Shield Plate Holder, and remove the Shield Plate Holder.
4. Remove the five screws (four C.B.P. M3 x 10 screws and one C.B.S. (P2) M3 x 10
screw) secure the Printer Mechanism.
Disassembly And Assembly
1
Left Rear
3) C.B.S. (P2) M3x10
Disassembling the Printer Mechanism
1) C.B.P. M3x10
(6±1 kgf.cm)
Printer Mechanism
2
1) C.B.P. M3x10
(6±1 kgf.cm)
Right Rear
3) C.B.S. (P2) M3x10
(6±1 kgf.cm)
5
Lower Housing
Figure 4-51. Screws that Secure the Printer Mechanism
Revision C
4
3
Step 2
Joint Tube
Waste Ink Tube
Fastener
Shield Plate Holder
(6±1 kgf.cm)
A
Step 3
B
18) C.B.P. 3x12
(6±1 kgf.cm)
86
Confidential