Led Behavior Table - Ubee DDW2600 Subscriber User Manual

Ubee Interactive
2.7.2
The following table describes what the device LEDs indicate.
Note: The WLAN LED is available on the DDW2600 only.
LED Power
Label:
Green
Color
CM driver init. On
Initialization
DS On
Scanning
DS Locked On
US Ranging On
US Ranged On
IP Init. and On
Registration
Network On
Access
Enabled
Network On
Access
Disabled
CM Normal On
Operation Operations,
Cable
Interface
Traffic,
Network
Access
Enabled
USB/WLAN/ On
Ethernet
Connected
USB/WLAN/ On
Ethernet
Traffic
Upgrade In On
Progress
DDW2600 Wireless & DDC2700 Commercial Cable Modem/Router Subscriber User Guide • May, 2010

LED Behavior Table

USB Sync Ready
Host
Green Green Green
Flash then Flash then Flash then
Off Off Off
Slow Flash Off
Slow Flash Off
On Slow Flash
On Slow Flash
On Fast Flash
Depends on
Ethernet
On On
Status, On if
Connected
On Off
On On
On, if
Connected
Slow Flash
On, if Slow Flash On
Connected
WLAN Eth-1 Eth-2
Green Green/Orange Green/Orange
Off Flash then Off Flash then Off
On
On
On
On
On
Depends on Depends on
Ethernet Ethernet
On
Status, On if Status, On if
Connected Connected
On
On
On, if On, if On, if
Connected Connected at Connected at
100Mbps, 100Mbps,
Orange if Orange
Connected at Connected at
10Mbps 10Mbps
Slow Flash if Slow Flash Slow Flash
Traffic
On, Slow On, if On, if
Flash if Connected Connected
Traffic
2.7.2 LED Behavior Table
Eth-3 Eth-4
Green/Orange Green/Orange
Flash then Off Flash then Off
Depends on Depends on
Ethernet Ethernet
Status, On if Status, On if
Connected Connected
On, if On, if
Connected at Connected at
100Mbps, 100Mbps,
if Orange if Orange if
Connected at Connected at
10Mbps 10Mbps
Slow Flash Slow Flash
On, if On, if
Connected Connected
11