Default Values/Device Logins; Wireless Defaults (For Ddw2600 Only) - Ubee DDW2600 Subscriber User Manual

Ubee Interactive
2.4

Default Values/Device Logins

This device is pre-configured with the following parameters:
Local Port Address: 192.168.0.1, Web Interface: http://192.168.0.1
Operation Mode: NAT Mode (WAN setting)
Subnet Mask: 255.255.255.0
Web/Device Interface Logins:
Subscriber
 Username: user
 Password: user
2.4.1
When initially connecting a wireless client to the wireless device (for example, a PC),
the following default values are used:
 SSID (System Set Identifier): The SSID is what the wireless device uses to
 Encryption Key: The device uses 128-bit WEP encryption by default. The WEP
 Broadcast Channel: The default broadcast channel is 1.
DDW2600 Wireless & DDC2700 Commercial Cable Modem/Router Subscriber User Guide • May, 2010

Wireless Defaults (for DDW2600 only)

advertise itself. The SSID is equal to the last 4 characters of the Cable RF
MAC address. Example:
If MAC Address is: 00028A1A345
SSID is: A345
Note: Refer to page 8
key is a 26 digit HEX value. This value is equal to the device MAC address
plus 14 zero's (all lower case without the colons). Example:
00028A1A345600000000000000 (MAC address + 14 Zero's)
to find the MAC address of the device.
2.4 Default Values/Device Logins
7