Chrysler 2004 Concorde Service Manual page 1482

23 - 112 WEATHERSTRIP/SEALS
FRONT DOOR MOUNTED
WEATHERSTRIP
REMOVAL
(1) Using a fork type prying tool, disengage push
pin fasteners attaching weatherstrip to lower door
(Fig. 4).
(2) Remove weatherstrip from door.
Fig. 4 FRONT DOOR MOUNTED WEATHERSTRIP
1 - FRONT DOOR
2 - PUSH-IN FASTENERS
INSTALLATION
(1) Place door mounted weatherstrip in position.
(2) Engage push pin fasteners to attach weather-
strip to lower door.
(3) Verify door alignment and seal
REAR DOOR BODY MOUNTED
WEATHERSTRIP
REMOVAL
(1) Remove door opening sill plate (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM - REMOVAL).
(2) Pull body mounted weatherstrip from fence
around door opening (Fig. 5).
Fig. 5 REAR DOOR BODY MOUNTED
WEATHERSTRIP
1 - REAR DOOR OPENING
2 - REAR DOOR BODY MOUNTED WEATHERSTRIP
3 - PINCH FLANGE
INSTALLATION
(1) Position color dot on weatherstrip at the B-pil-
lar upper corner.
(2) Engage weatherstrip on the fence at upper
B-pillar and work down the B-pillar.
(3) Engage weatherstrip along the header and
down the C-pillar.
(4) Engage weatherstrip along the sill. There may
be slack material, work the slack material to the
front of the opening.
(5) Install the door opening sill plate (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM - INSTALLA-
TION).
(6) Verify weatherstrip sealing.
LH