19 - 18
COLUMN
COLUMN (Continued)
(20) Remove the two screws attaching the lower
shroud to the steering column (Fig. 15). Remove the
lower shroud from the steering column.
Fig. 15 Lower Shroud Attaching Screws
1 - LOWER SHROUD
2 - MOUNTING SCREWS
(21) Remove the wiring harness connectors from
the clockspring (Fig. 16).
Fig. 16 Wiring Harness Connection To Clock Spring
1 - WIRING HARNESS CONNECTORS
2 - CLOCKSPRING
(22) Remove the two screws (Fig. 17) mounting the
clockspring to the steering column. Remove the clock-
spring from the steering column.
Fig. 17 Clockspring Location
1 - CLOCKSPRING
2 - MOUNTING SCREWS
(23) If the vehicle is equipped, disconnect the wire
harness connector at the SKIM module. Remove the
mounting screw and unclip the module from the key
cylinder halo bezel.
(24) Remove the wiring harness from the routing
clip on the top of the multi-function switch. Remove
the 2 screws (Fig. 18) mounting the multi-function
switch to the steering column. Remove the multi-
function switch, with the wiring harness attached,
from the steering column.
Fig. 18 Multi-Function Switch
1 - MULTIFUNCTION SWITCH
2 - MOUNTING SCREW
3 - WIRING HARNESS
4 - STEERING COLUMN
5 - MOUNTING SCREW
LH