Chrysler 2004 Concorde Service Manual page 1267

LH
FINAL DRIVE (Continued)
(24) Screw in the inner adjuster using special tool
6502B (Fig. 203). The inner adjuster should be
screwed in until under-flush with inside of the case
(viewed from differential side).
If differential was not disassembled, refer to Step
25.
Fig. 203 Inner Adjuster Installation
1 - SPECIAL TOOL 6502–B
2 - INNER DIFFERENTIAL ADJUSTER
DIFFERENTIAL ASSEMBLY
(1) Install differential carrier bearings using an
arbor press, driver handle C-4171, and Tool C-4340
(Fig. 204).
Fig. 204 Carrier Bearing Installation
1 - ARBOR PRESS
2 - HANDLE C-4171
3 - SPECIAL TOOL C-4340
(2) Install differential pinion and side gears, and
pinion shaft (Fig. 205).
Fig. 205 Install Differential Pinion Shaft and Remove
Pinion Gears and Side Gears
1 - DIFFERENTIAL CARRIER
2 - PINION SHAFT
3 - SIDE GEARS
CAUTION: Use a new roll pin upon reassembly.
(3) Install pinion shaft roll pin (Fig. 206).
Fig. 206 Install Pinion Shaft Roll Pin
1 - HAMMER
2 - PIN PUNCH
3 - PINION SHAFT
4 - DIFFERENTIAL CARRIER
5 - DIFFERENTIAL BEARING
TRANSAXLE 21 - 87