Chrysler 2004 Concorde Service Manual page 1481

LH
DRIP RAIL WEATHERSTRIP (Continued)
Fig. 2 DRIP RAIL WEATHERSTRIP
1 - A-PILLAR
2 - WINDSHIELD
3 - FASTENERS
4 - DRIP RAIL WEATHER-STRIP
5 - FASTENERS
INSTALLATION
(1) Place drip rail weatherstrip in position on vehi-
cle.
(2) Start position clip at the fender tip.
(3) Press down till holes are align with fastener
holes in the body.
(4) Install fasteners to attach drip rail weather-
strip to roof rail.
(5) Close doors and verify fit.
1 - FRONT DOOR MOLDING
2 - GLASS RUN WEATHERSTRIP
3 - REAR GLASS RUN CHANNEL
Fig. 3 DOOR GLASS RUN WEATHERSTRIP
WEATHERSTRIP/SEALS 23 - 111
FRONT DOOR GLASS RUN
WEATHERSTRIP
REMOVAL
(1) Remove door glass (Refer to 23 - BODY/DOOR
- FRONT/DOOR GLASS - REMOVAL).
(2) Loosen side view mirror.
(3) Pull weatherstrip from lower front channel
above door latch.
(4) Pull run weatherstrip from window frame
channel (Fig. 3).
INSTALLATION
(1) Clean butyl material from door flange area.
(2) Place door run weatherstrip in position on win-
dow frame channel.
(3) Push door run weatherstrip into window frame
channel.
(4) Push weatherstrip into lower front channel
above door latch.
(5) Install door glass (Refer to 23 - BODY/DOOR -
FRONT/DOOR GLASS - INSTALLATION).
(6) Tighten side view mirror.
4 - FRONT DOOR
5 - FRONT GLASS RUN CHANNEL