Chrysler 2004 Concorde Service Manual page 1590

24 - 22 CONTROLS
SUN SENSOR (Continued)
INSTALLATION
(1) Connect the wiring harness connector to the
sensor and position in the vehicle.
(2) Install the two sensor fasteners.
(3) Install the instrument panel top cover(Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL TOP COVER - INSTALLATION).
(4) Connect the negative battery cable remote ter-
minal to the remote battery post(Refer to 8 - ELEC-
TRICAL/BATTERY
INSTALLATION).
CAUTION: The sun sensor must protrude approxi-
mately 1/4 inch above the instrument panel top
cover. This will ensure proper operation.
If the sensor does not protrude 1/4 inch, perform
the following procedure:
• Confirm that the top cover is properly installed
• Remove the top cover
• Remove fasteners from sun sensor
• Install one 1/4-20 nut per fastener under the sun
sensor so that it is shimmed higher
• Reinstall the sun sensor. Do not overtighten
screw. If a longer screw is required, use 8-15x1 inch.
SYSTEM/CABLES -
LH