Chrysler 2004 Concorde Service Manual page 1291

LH
INPUT CLUTCH ASSEMBLY (Continued)
(21) Remove input hub tapered snap ring (Fig.
282).
Fig. 282 Input Hub Tapered Snap Ring
1 - INPUT SHAFT
2 - INPUT HUB SNAP RING (TAPERED SIDE UP WITH TABS IN
CAVITY)
3 - SNAP RING PLIERS
(22) Tap on input hub with soft faced hammer and
separate input hub from OD/Reverse piston and
clutch retainer (Fig. 283) (Fig. 284).
Fig. 283 Tap on Input Hub
1 - INPUT SHAFT AND HUB ASSEMBLY
2 - PLASTIC HAMMER
Fig. 284 Input Hub Removed
1 - INPUT SHAFT AND HUB ASSEMBLY
2 - INPUT CLUTCH RETAINER
3 - O-RING
4 - SEAL
5 - OVERDRIVE/REVERSE PISTON
(23) Separate clutch retainer from OD/Reverse pis-
ton (Fig. 285).
Fig. 285 Pull Retainer from Piston
1 - OVERDRIVE/REVERSE PISTON
2 - INPUT CLUTCH RETAINER
TRANSAXLE 21 - 111