Chrysler 2004 Concorde Service Manual page 1211

LH
42LE AUTOMATIC TRANSAXLE (Continued)
(11) Install snap ring and remove compressor tool
(Fig. 90).
Fig. 90 Install Snap Ring
1 - SNAP RING OPENING MUST BE BETWEEN SPRING LEVERS
(AS SHOWN)
2 - SNAP RING PLIERS
3 - TOOL 6057
(12) Install rear carrier front bearing cone (Fig. 91).
Fig. 91 Install Rear Carrier Front Bearing Cone
1 - ARBOR PRESS
2 - SPECIAL TOOL C-4171
3 - SPECIAL TOOL 6052
4 - REAR CARRIER
(13) Check output bearing preload. Output bear-
ing preload must be checked and/or adjusted if
any of the following items have been replaced:
• Output shaft (rear carrier assembly)
• Output shaft bearings
• Transaxle case
(a) PRELOAD CHECK/SHIM SELECTION:
Install rear output shaft bearing cone and special
tool 6618A (Fig. 92).
(b) Install special tool 6618A (Fig. 93). Lightly
tighten retaining screws. Screws should be below
the plate surface, but do not snug screws.
(c) Turn case over on arbor press so that the
plate is resting on the press base. CAUTION: The
output shaft will extend through the hole of
tool 6618A. Ensure your press table has clear-
ance for the output shaft.
Fig. 92 Bearing Installation
1 - SPECIAL TOOL 6618–A
2 - REAR OUTPUT SHAFT BEARING
Fig. 93 Special Tool Installed
1 - SPECIAL TOOL 6618–A
TRANSAXLE 21 - 31