LH
WHEEL MOUNTING STUDS - REAR (Continued)
INSTALLATION
CAUTION: DO NOT hammer studs into the hub
flange. If a stud is installed in such a manner, dam-
age to the hub and bearing assembly may occur
leading to premature bearing failure.
(1) Install wheel stud into stud hole in hub and
bearing assembly.
(2) Position the hub and bearing assembly face
down with stud pointing down into the well of the 21
mm socket. The hydraulic press ram must line up
with the stud (Fig. 38).
(3) Press the stud into the hub flange until it bot-
toms.
(4) Remove the hub and bearing assembly from
the press.
(5) Install the hub and bearing on the vehicle.
(Refer to 2 - SUSPENSION/REAR/HUB / BEARING -
INSTALLATION)
Fig. 38 Wheel Stud Installation
1 - HUB AND BEARING ASSEMBLY
2 - PRESS RAM
3 - WHEEL STUD
4 - 21mm IMPACT SOCKET
TIRES/WHEELS 22 - 23