Chrysler 2004 Concorde Service Manual page 1213

Hide thumbs Also See for 2004 Concorde:

Table of Contents

42LE AUTOMATIC TRANSAXLE (Continued)

(h) The new nut must be staked after the correct

turning torque is obtained (Fig. 97) (Fig. 98). Use

special tool 6639 to stake output shaft nut and spe-

cial tool 6589 to stake transfer shaft. CAUTION:

Failure to stake shaft nuts could allow the

nuts to back-off during use.

Fig. 97 Staking Output Shaft Nut

1 - ARBOR PRESS

2 - STAKING TOOL

Fig. 98 Properly Staked Nut

1 - BOTTOMED IN SLOT

2 - CORRECTLY STAKED NUT

(14) Apply Mopar ATF RTV (MS-GF41) as shown

in (Fig. 99). Install main sump baffle to transaxle

case (Fig. 100) and torque screw to 5 N·m (45 in.

Fig. 99 Properly Applied Sealant

2 - BACK SIDE OF VENT BAFFLE

Fig. 100 Main Sump Vent Baffle Location

1 - OUTPUT SHAFT NUT

2 - MAIN SUMP VENT BAFFLE

3 - TRANSFER SHAFT NUT

4 - TRANSFER SHAFT

5 - VENT BAFFLE RETAINING SCREW

6 - OUTPUT SHAFT

TRANSAXLE 21 - 33

Chapters

Table of Contents