Chrysler 2004 Concorde Service Manual page 1268

21 - 88 TRANSAXLE
FINAL DRIVE (Continued)
(4) Install side gear, stub shaft, and c-clip to differ-
ential support plate (Fig. 207).
Fig. 207 Install Side Gear, Stub Shaft, and C-Clip
1 - SIDE GEAR
2 - STUB SHAFT
3 - "C" CLIP
CAUTION: Ring gear bolts are not reusable. When
reassembling, use new bolts.
CAUTION: When assembling differential halves, line
up notches on side of carrier.
(5) Assemble support plate to differential. Install
ring gear and NEW bolts. Torque bolts to 95 N·m (70
ft. lbs.) (Fig. 208).
Fig. 208 Install Ring Gear Bolts
1 - RING GEAR BOLTS
2 - RING GEAR
(25) Install differential assembly into the transaxle
case (Fig. 209).
Fig. 209 Differential Assembly Installation
1 - DIFFERENTIAL ASSEMBLY
(26) Install differential cover (Fig. 210). Do not
apply silicone sealant at this time. All bolts should be
installed and tightened.
Fig. 210 Differential Cover Installation
1 - SIDE COVER
LH