Chrysler 2004 Concorde Service Manual page 1295

LH
INPUT CLUTCH ASSEMBLY (Continued)
(8) Install UD piston return spring and Tool 5067
as shown in (Fig. 298).
Fig. 298 Seal Compressor Special Tool 5067
1 - PISTON RETURN SPRING
2 - SPECIAL TOOL 5067
3 - INPUT CLUTCH RETAINER
(9) Using Tool 5059A and an arbor press, install
the UD spring retainer and snap ring. (Fig. 299),
(Fig. 300) Compress just enough to install snap ring.
CAUTION: Compress return spring just enough to
install snap ring.
Fig. 299 UD Return Spring and Retainer
1 - UNDERDRIVE SPRING RETAINER
2 - SNAP RING
3 - SEAL
4 - PISTON RETURN SPRING
Fig. 300 Install UD Spring Retainer and Snap Ring
1 - ARBOR PRESS RAM
2 - SNAP RING PLIERS
3 - SNAP RING
4 - OD/REVERSE PISTON
5 - TOOL 5067
6 - TOOL 5059A
(10) Install the UD clutch pack (four fibers/four
steels) (Fig. 301). Leave the top disc out until after
the snap ring is installed.
Fig. 301 Underdrive Clutch Pack
1 - CLUTCH PLATE
2 - ONE UD CLUTCH DISC
3 - CLUTCH DISC
TRANSAXLE 21 - 115