Wsw34 (Function Setting 12) - Ricoh G157 Service Manual

MAINTENANCE MODE

WSW34 (Function setting 12)

Selector
No.
Erasing time length of ICM tone
recorded preceding the tone
detection starting point in the
1–3
case of automatic line
disconnection due to no voice
signal received
No. of CNG cycles to be detected
(when the line is connected via
4, 5 the external telephone in the
external TAD mode or via the
machine in F/T mode)
Number of DTMF tone signals for
6, 7 inhibiting the detection of CNG
during external TAD operation
8 Not used.
NOTE: Selectors 1 through 5 are applicable to models equipped with built-in
TADs.
Selectors 1 through 3: Erasing time length of ICM tone recorded preceding the tone
detection starting point in the case of automatic line disconnection due to no voice
signal received
If the machine has disconnected the line after detection of disconnection tone in
ICM recording, it erases tone recorded preceding the tone detection starting point
for the time length set by these selectors.
Selectors 4 and 5: No. of CNG cycles to be detected (when the line is connected via
the external telephone in the external TAD mode or via the machine in F/T mode)
The machine interprets a CNG as an effective signal if it detects a CNG signal by
the number of cycles specified by these selectors when the line is connected via
the external telephone in the external TAD mode or via the machine in F/T mode.
Selectors 6 and 7: Number of DTMF tone signals for inhibiting the detection of CNG
during external TAD operation
If the machine receives this specified number of DTMF tone signals during external
TAD operation, it will not detect CNG afterwards.
If these selectors are set to "1, 1," the CNG detection will not be inhibited.
G157
CÓPIA NÃO CONTROLADA
Function
5-76
CÓPIA NÃO CONTROLADA
Setting and Specifications
No. 1. 2. 3.
0 0 0: 0 sec.
0 0 1: 1 sec.
0 1 0: 2 sec.
0 1 1: 3 sec.
1 0 0: 4 sec.
1 0 1: 5 sec.
1 1 0: 6 sec.
1 1 1: 7 sec.
No. 4. 5.
0 0: 0.5
0 1: 1
1 0: 1.5
1 1: 2
No. 6. 7.
0 0: 3
0 1: 2
1 0: 1
1 1: 0
SM